Equipment List

MILLING CAPABILITIES

1) Cincinnati Milacron 750 ARROW CNC Vertical Machining Center (1996)
* 30” X-Axis, 20” Y-Axis, 20” Z-Axis machining range
* 21 tool capacity
* 15 horsepower spindle motor

2) Cincinnati Milacron 500 DART CNC Vertical Machining Center (2000)
* 20” X-Axis, 20” Y-Axis, 20” Z-Axis machining range
* 21 tool capacity
* 15 horsepower spindle motor

3) Chevalier CNC Knee Mill
* 30” X-Axis, 14” Y-Axis, 6” Z-Axis
* Unlimited tool capacity, manual tool changer
* 7 horsepower spindle motor

4) Chevalier CNC 1418 vmc-40 Vertical Machining Center (2004)
* 17.700” X-Axis, 13.800” Y-Axis, 15” Z-Axis
* 12 tool capacity
* 7.5 horsepower spindle motor (10,000 rpm)

TURNING CAPABILITIES

1) Daewoo Puma 2000 SY CNC turning center
* 11.400 diameter, 20” length turning capacity
* Y axis with 4.000 travel.
* 20 horsepower spindle motor
* Full contouring main and sub spindle
* 12 tool capacity (all accept rotating tool holders)
* 5 horse power / 5,000 rpm rotating tools
* 10 horsepower sub-spindle ( full contouring )
* LNS bar feeder
* 3-jaw chuck, and 3J collet capability both main and sub-spindle

2) Daewoo Puma 230MSA CNC turning center
* 11.400 diameter, 20” length turning capacity
* 20 horsepower spindle motor
* Full contouring main spindle
* 12 tool capacity (all accept rotating tool holders)
* 5 horse power / 6,000 rpm rotating tools
* 7.5 horsepower sub-spindle ( 5 degree indexable)
* LNS bar feeder
* 3-jaw chuck, and 3J collet capability both main and sub-spindle
*

3) Daewoo Puma 8S CNC turning center
* 10 ½” diameter, 20” length turning capacity
* 12 tool capacity
* 25 horsepower spindle motor
* 3-jaw chuck, 2-jaw chuck, and 5c collet capability

4) Victor 1630 engine lathe (two machines of this type)
* 23 ½” diameter, 25” length turning capacity
* Travel dial equipped
* 7 horsepower spindle
* 3-jaw chuck, 4-jaw chuck, face plate, and 5c collet capability

QUALITY CONTROL

1) Quality Control Department operating in compliance with MIL-I-45208
* 350 square feet of environmentally controlled floor space
* All inspection equipment calibrated in accordance with MIL-STD-45662
* Recall and calibration tracked by computer surveillance